MicroSys -> Products -> CompactPCI -> SBC Pentium -> CPM1

Deutsche Fassung

Hi-Res Pictures Hi-Res Picture #1 Page Content Block Diagram Software-Support Related Products

CPM1

CPM, the first generation of 6U, single slot single board computer (SBC) for CompactPCI that integrates the Intel® Pentium® M processor with PIGMG 2.16 Support.

The CPM takes advantage of the 1,6 GHz Pentium M's low power consumption in a SBC and starts with 256MB DDR-266 RAM. All types of Pentium M Processors are supported. The CPM features one PMCX Site with Front and Rear IO, various integrated DVO/RGB, USB 2.0, ATA/150, UART and Serial ATA. A VGA/DVI connector, two USB 2.0 ports, a 10/100/1000BaseTX interface, COM1 and PMC Site are all accessible on the front panel.

Additional I/O such as Serial ATA, VGA/DVI Video, GB Ethernet, and two more USB 2.0 ports are accessible on Rear I/O modules. The two 1000BaseTX ports of the Intel 82546 are routed to the backplane in compliance with PICMG 2.16. The CPM is a very versatile module. Optional versions can be used purely as PICMG 2.16 blades and/or as CompactPCI modules in peripheral or system slot modes of operation. The PLX PCI6254 Universal bridge permits this flexibility and it supports 64 bit wide PCI interfacing at 66 MHz on the backplane. Lower power, lower cost variations of the PICMG 2.16 compliant blade that leave off the 6300ESB are also available.

Operating system support includes Windows XP®, QNX®, Linux®, and VxWorks®. MicroSys Electronics GmbH's CPM will be available in Q4/2004.

Features

• Processor
  Pentium M Processor2 MB of L2 Advanced Transfer Cache, available in Low Voltage Version at 1.6 GHz.
• 855GME and 6300ESB Chipset400 MHz System Bus.
  Ultra ATA 100/66/33 IDE protocol, PCI-X expansion offers 64 bits @ 66 MHz data transfer capability, Integrated Graphics, Chipset includes DRAM controller, USB 2.0 interface, two Serial ATA/150 ports, RTC, NV-RAM, standard PC timers, Ultra DMA, and interrupt logic.
• DDR SDRAM
  DDR-266 support with a memory bandwidth of 2.1 GB/s, Stuffing options for 256MByte, 512MByte or 1GByte.
• Single-slot
  Single-slot with a low-profile heat sink
• CompactPCI
  PLX Technology's PCI 6254 dual mode universal asynchronous 64-bit, 66Mhz PCI-to-PCI bridge. Universal Bridge supports system slot and peripheral slot operation. Transparent or Non-transparent modes for multi-processing. 1 KB Buffer for efficient PCI-PCI bridging, PICMG 2.16 Compliant. Hot Swapping is supported Lower cost blade versions available without CompactPCI.
• PMC Expansion
  One PMCX site with 64 bit @ 66 MHz bandwidth is available on-board. I/O is routed through the P3 connector as well as through the front panel.
• Ethernet
  An Intel 82546 Ethernet controller supports two 10/100/1000BaseTX Ethernet ports routed to the P0 connector in compliance with Vita 31.1 for backplane fabric switching or for alternate routing to an optional rear I/O card. An 82541 provides one 10/100/1000BaseTX port that is accessible from the front panel.
• Graphics
  6300ESB I/O Controller Hub provides an integrated 32-bit 3D core at 133 MHz. DVI/RGB is accessible at the front panel via a high-density DVI-I connector and routed through P5, optionally.
• IDE
  Primary ATA/100 DMA IDE interface is accessible from the P5 connector. PIO and bus master support. Secondary IDE port is routed to a Type II compatible CompactFlash connector for on-board booting.
• BIOS
  General Software's flash-based system BIOS with a variety of boot options including CD-ROM and PXE over Ethernet. Customized versions can be provided.
• Watchdog
  Programmable watchdog timer for system recovery.
• Front Panel I/O
  DVI-I/VGA, Dual USB 2.0, 10/100/1000BaseTX port (Intel 82541PI), COM1 and one PMCX Breakout.
• IDE and PMC I/O (routed through P5)
  Low Pin Count Bus(LPC) interface runs through P5, like COM ports, Floppy Disk Controller, Mouse/Keyboard interface, and LPT1 through an LPC compatible Super I/O device. Optionally COM2 and two distinct USB 2.0 ports may be routed through P5 instead of the LPC interface for applications that cannot use a rear plug-in card. Two Serial ATA ports, two 10/100/1000BaseTX ports and a VGA/DVI port (routed through P5).
• Extended Temperature Version
  Expanded temperature range and high shock and vibration operating characteristics are optional.
• Power Requirements
  TBD

Block Diagram

 Return to Top

Software-Support

• Linux
• Windows/XP
• QNX
• VxWorks

 Return to Top

Related Products

• CHC    Single Slot SBC with Intel® Low Voltage Xeon™ Processor. 6U CompactPCI Controller supports Dual Gigabit Ethernet (PIGMG 2.16), Serial ATA and U320 SCSI.
• DPM    Single Slot SBC with the Intel® Pentium® M Processor. VITA 31.1 compliant 6U VMEbus board with one PMCX Site.
• DHC    Single Slot SBC with Intel® Low Voltage Xeon™ Processor. 6U VMEbus Board with one PMCX Site and Dual Gigabit Ethernet on Front Panel.
• DMC    Single Slot SBC with Intel® Pentium III Processor. 6U VMEbus Karte with dual PMC sites, Fast Ethernet and Graphics on Front Panel.
• RPM    Rugged Single Slot SBC with the Intel® Pentium® M Processor. VITA 31.1 compliant 6U VMEbus board with one PMCX Site.

 Return to Top